- Contact Person : Mr. Chen Jack
- Company Name : Jiaxing Jinchang Electron Technology Co., Ltd.
- Tel : 86-573-83692605
- Fax : 86-573-83698635
- Address : Zhejiang,Jiaxing,North Side(4/F, 1th Building, Wanli Petrochemical limited liability company), No. 4 bridge, Chengnan Road, Economic Development Zone
- Country/Region : China
(Manufactory) Rubber WCDMA/SCDMA Antenna
Related Product Searches:(Manufactory) Rubber WCDMA/SCDMA Antenna,High Quality WCDMA SCDMA Antenna,WCDMA SCDMA Antenna JCG806
3.Electrical Characteristics
3.1 GSM Antenna
Form 1
No. | Item | Specifications |
1 | Frequency(MHz) | 824~894 MHz/1710~1990 MHz 880~960 MHz/1710~1990 MHz 1920~2170 MHz |
2 | V.S.W.R(in BW ) | ≤2.5:1 |
3 | Gain(Zenith) | 2 dBi |
4 | Polarization | Vertical |
5 | Impedance | 50 Ω |
3.2 Mechanical
Form 2
No. | Item | Specification |
1 | Cable | — |
2 | Connector | SMA |
3 | Plastic Housing | Black |
5. Environmental Specifications
Post Environmental Tolerance (Refer to the form 1~2 )
Condition:Temperature range 25±3°C
Relative Humidity range 55~75%RH
Operating Temperature range -40°C~+85°C
Storage Temperature range -40°C~+100°C
5.1 Moisture Proof
The device should satisfy the electrical characteristics specified in form 1~2 after exposed to the temperature 40±2°Cand the relative humidity 90~95% RH for 96 hours and 1~2 hours recovery time under normal condition.
5.2 Vibration Resist
The device should satisfy the electrical characteristics specified in form 1~2 after applied to the vibration of 10 to 55Hz with amplitude of 1.5mm for 2 hours each in X , Y and Z directions.
5.3 Drop Shock
The device should satisfy the electrical characteristics specified in form 1~2 after dropping onto the hard wooden board from the height of 30cm for 3 times each facet of the 3 dimensions of the device.
5.4 High Temperature Endurance
The device should satisfy the electrical characteristics specified in form 1~2 after exposed to temperature 80±5°Cfor 24±2 hours and 1~2 hours recovery time under normal temperature.
5.5 Low Temperature Endurance
The device should also satisfy the electrical characteristics specified in form 1~2 after exposed to the temperature -40°C±5°Cfor 24±2 hours and to 2 hours recovery time under normal temperature.
5.6 Temperature Cycle Test
The device should also satisfy the electrical characteristics specified in form 1~2 after exposed to the low temperature -25°C and high temperature +85°C for 30±2 min each by 5 cycles and 1 to 2 hours recovery time under normal temperature.
6.Weatherproof
Put the antennas in 1m deep water for 12h, and find 100% waterproof
